PCB Design Practical-Full Wave Rectifier Circuit

Design and create single sided PCB Layout for Full wave rectifier circuit.

AIM: To design the PCB Layout for full wave rectifier circuit with Multisim Software.

APPARATUS REQUIRED:

1. Latest computer.
2. Multisim Software version 12.0
3. Laser Printer.

PROCEDURE:

Open Multisim software and click => File => New file =>Design1.
From file menu click “save as” in Desk Top and rename the Design1 to your circuit name.
Go to component toll bar and select the component as per your circuit diagram and save it.

Test your circuit with simulation “run” button.
Remove input transformer and output multimeter with replacement of connector as per diagram.

Change the properties of all component into PCB Mode.

Transfer MULTISIM to ULTIBOARD single side PCB Design.

Got to Transfer icon => Transfer to ULTIBOARD 12.0 the save the file and got import netlist and click ok.

Select layer for single side PCB with help of PCB properties icon.

Set the Track width = 30, trace to trace and trace to pad =10.

Select the all components into board edge and make it as small PCB.
Select tools icon and click auto route to make PCB.

RESULT:

Thus the design of single sided PCB layout for full wave rectifier circuit with multisim software CAD tool was done.

PCB DESIGN PRACTICAL LAB MANUAL DOWNLOAD: CLICK HERE.
Simulation Lab Manual: Click Here.
All PCB Design Layout Experiments:
1. Full wave rectifier.
2. Bridge rectifier.
3. Common Emitter Amplifier.
4. Amplitude Modulator.
5. Frequency Modulator.
6. Astable Multivibrator using 555 IC.
7. Half Adder using logic Gates.
8. Full Adder using Logic gates.
9. 4 Bit Binary counter using D Flip Flops.
10. 4 Bit Shift register (PIPO) using JK Flops.
11. Positive voltage regulator using 7895 and 7812 IC.
12. Analog Multiplier using 741 IC.
13. Flashing LEDs using 555 IC.
14. Fan Regulator.
15. Liquid Level Controller.