Proteus Software Tutorial

The Proteus 8 Design Suite software can interact the embedded projects with LED, LCD displays, and switches also interface with software sensors.
p1
In need of practical implementation of the projects circuits, we have to test with our C program and how it works or not.
Proteus 8 Design suite is a on of the Virtual system Modeling (VSM) with spice circuit simulation, with animated electronic components.
Here how to create and simulation with microcontroller and C simple program. Free demo software is available with www.labcenter.com
Please follow the below given steps.,
STEP-1: CLICK, New Project And give Name for your Project.
p2 STEP-2: Click Schematic radio button with default then Next.
p4
STEP-3: Select create firmware project then Nest.
Select controller: Iam using AT89c51. so select At89C51.
p7  STEP-4. Select compiler: Here Iam using Keil, so select Keil of r 8051 the Next.
p8
STEP-5: Note the following steps are correct or not.
p9
STEP-6. Select source code window and then write your C program.
p11
STEP-7. Draw your circuit diagram with the help of below mentioned steops.
p12
STEP-8: Component selection mode.
p13
STEP-9. Click P means Pick device and write in keyword box which component you wants.
p14
STEP-10. Here iam using led and resistor only.
p15
p17
STEP-11. Place your components in schematic window and connect as per your diagram with the help of mouse.
p18
STEP-12: Click Terminal mode icon and use 5v power supply like namely power and ground.
p19
STEP-13. Here we can convert C program into Hex code. So Click Build button and rebuild and then Build. The result we can get HEX code with the help of Keil software.
p27
STEP-14. Check 0 Warring and 0 Errors.
p23
STEP-16. Click RUN of Play Button to simulate your project.
p24 STEP-17. Finally LED blinking with your C Program.p20

Leave a Reply

Your email address will not be published. Required fields are marked *